Consumption
Reading of the available data and comparison with the expected behaviour of the building.
Understand why a building consumes, where the losses are and which actions are really a priority before committing to investments.
A building can consume too much for several reasons: envelope, heating, settings, use, ventilation, comfort or a combination of these factors. The audit avoids treating only the symptom.
Reading of the available data and comparison with the expected behaviour of the building.
Analysis of facades, windows, roof, floors and the main thermal weak points.
Heating, hot water, ventilation and consistency with the building’s needs.
Identify what deserves to be addressed first rather than piling up generic recommendations.
Weigh several possible actions by their effect, their technical consistency and the overall project.
Where needed, complete with a CECB+, a thermal balance, a simulation, the IDC or an envelope study.
After the intervention, compare the results with the expected objectives and the actual consumption.
An energy audit is for understanding how your building actually behaves: where the losses go, what the envelope constrains, what the installations are worth. It sets out to answer one question: what should be done now, and in what order? The CECB is the right choice when your case calls for a recognised certificate rather than a tailored analysis. If you are unsure, describe your situation: we help you identify the first useful step.
Start by identifying what to improve first and setting renovation priorities before committing to works. An energy audit gives a documented understanding of the building as it stands, identifies weak points and improvement potential, and ranks the measures worth considering. Once the analysis is done, energy renovation means defining the priority measures and their sequence, comparing construction and energy variants, then supporting the project.
Before choosing an installation, check what the building needs: its heating needs, the condition of its envelope (walls, roof, windows, thermal bridges) and the existing heating, hot water and ventilation installations. The aim is that each measure is decided in full knowledge of its effect on the rest of the building.
No. The estimate provides an indicative order of magnitude and does not replace a measured IDC or an energy audit. Public information is a starting point: it is not an audit, a diagnosis or a performance assessment. The condition of the envelope, the quality of the installations, real comfort, renovation potential and the cost of the work appear in no register. They are established through engineering analysis and a site visit.
We help you understand where the problem lies before deciding on works.
Fill out the form below. We reply within 1 business day.